How to maintain the cone crusher can prolong the service life

Cone crusher is a kind of crushing equipment widely used in metallurgy, mining, chemical industry, cement and other industrial fields. The length of its service life directly affects the efficiency of work. Therefore, correct maintenance and maintenance is an important means to prolong the service life of the machine and reduce the cost. So how to maintain the cone crusher can prolong its life?

1. Bearing maintenance

The wear of the cone crusher is relatively large during use, and the bearing is a component that is relatively prone to problems. Therefore, it is very important to do a good job in the maintenance of the bearings and increase the service life of the crusher bearings.

1. Regularly check the lubrication of the bearings, and replace the lubricating oil in time to ensure sufficient lubrication of the bearings.

2. Regularly check the temperature of the bearing, if the bearing is overheated, stop the machine immediately for inspection.

3. Regularly clean the bearings to prevent dust and debris from entering the bearings and affecting the normal operation of the bearings.

4. Check the tightness of the bearing to ensure that the bearing is well sealed to avoid leakage of lubricating oil.

Cone crusher

2. Lubrication and maintenance

Pay attention to the lubrication of the cone crusher equipment, always pay attention to and lubricate the friction surface in time, so as to ensure the normal operation of the cone crusher and prolong the service life of the equipment. The grease added to the housing accounts for 50-70% of the volume and must be replaced at least once every three months.

3. Routine maintenance

In order to ensure that the cone crusher is in good technical condition and can be put into operation at any time, reduce downtime, improve the utilization rate of the crusher, reduce wear and tear of the crusher, and prolong the service life of the crusher, regular maintenance of the cone crusher is very important.

1. Regularly check whether the connecting bolts of each part of the crusher are loose or cracked, and repair or replace them in time.

2. Check whether the belt of the crusher is worn or loose, and adjust or replace it in time.

3. Regularly check whether the electrical system of the crusher is normal, whether there is a short circuit, etc., and troubleshoot in time.

4. Regularly check whether the safety protection device of the crusher is intact, and repair or replace it in time.