The impact crusher
bears a very important secondary crushing production task both in the stone production line and in the sand production line. The production process is directly into the impact crusher after a crushing, and the hammer is driven by the motor. The liner is subjected to impact crushing production, and the wearing parts of the counter crusher are the hammer and the liner.
The whole impact crusher is seriously damaged by the hammer, because the hammer needs to be beaten and crushed continuously, although the hammer of the impact crusher is made of high manganese steel, due to the repeated impact and grinding of the material, Extremely fast wear. The repair method is either a reversing position or a surfacing repair process, but attention should be paid to the weight balance of the rotor during the repair process.
Impact crusher belongs to large-scale crushing equipment. The whole casing is made of cast steel, but it is worthy of everyone's attention that the counter crusher is strictly forbidden to enter the iron during the crushing production. If the rotor has problems, it can be welded. Dealing with or replacing a new rotor, after the rotor is repaired, it is still necessary to pay attention to the balance of the rotor. Only in this way can the normal production be achieved.
In general, the impact crusher needs to be used according to its own situation when it is used for production. It must be produced strictly according to the manufacturer's technical specifications. Unusual use will cause economic losses in the later stage.