In the production process of sand making, we not only have to choose the right sand making machine, but also pay attention to the faults that occur during use. Some failures will inevitably occur after the sand making machine has been used for a long time. Here, Jiaozuo Zhongxin reminds everyone that when the sand making machine
is abnormal during use, it should immediately s* the operation and troubleshoot the equipment to avoid unnecessary causes. The following summarizes several problems and solutions for everyone:
1. Abnormal vibration of sand making machine
1. If the material entering the sand making machine is too large and causes abnormal vibration, you can check the feed size of the stone.
2. When the impeller of the sand making machine is unevenly worn, it will cause abnormal vibration of the machine. At this time, you can check the wear of the impeller and alloy hammer head.
3. The unbalance of the sand machine impeller causes abnormal vibration, so the sand machine needs to be adjusted.
4. Abnormal vibration caused by improper foundation treatment of the sand making machine, check whether the anchor bolt is loose, and fix it in time.
Sand making machine
Second, the sand machine bearing heat
1. The lack of oil and too much oil in the bearing of the sand making machine will cause the bearing to heat up. You can check the oil level when it is hot.
2. Damage to the bearing of the sand making machine will also cause the bearing to heat up. Check and replace the bearing in time.
3. If the upper cover of the bearing body of the sand making machine is too tight, the bolts should be adjusted to properly adjust the looseness.
3. Belt turning of sand making machine
1. The belt of the sand making machine is worn, and a new belt can be replaced.
2. There may be a problem with the belt installation. The pulley needs to be adjusted on the same plane.
3. Check the quality of the triangle belt of the sand making machine to see if there is any problem with the quality.
4. The particle size of the sand making machine is too large
1. Check the wear of the alloy hammer head and side impact plate of the sand making machine. The alloy hammer head and side impact plate can be repaired and used, and can be replaced if necessary.
2. Check the particle size of the sand making machine. The material is one of the factors that affect the output of the sand making machine. When the particle size is too large, it will also cause the discharge size of the sand machine to be too large.
Five, the sand making machine has metal collision sound
1. The inner lining board or impeller wearing parts of the sand making machine fall off, and it is necessary to s* and re-tighten the parts.
The sand making machine plays an irreplaceable role in the ore equipment and is currently the * effective, practical and reliable sand making equipment. The above introduces you to the five common faults and solutions in the sand making process of the sand making machine. Other failures should not be taken lightly. S* and check immediately to avoid damage to other components.