widely used, the benefits of crushing in the crushing industry are also very impressive. However, it is often the case that the machine is not operating properly, which will affect the construction time. Therefore, how to ensure the normal operation of the jaw crusher is a concern of users.
First, regular maintenance and overhaul. Whether the jaw crusher can run normally, besides the correct operation, the maintenance depends on the maintenance. The maintenance of the equipment is the basis of the equipment maintenance. In use, it is necessary to perform maintenance and diligent maintenance. By grasping the wear cycle of new equipment parts, defects of equipment parts can be found early, and repairs and replacements can be made in a timely manner, so that the equipment cannot reach serious situations that cannot be repaired and scrapped. Therefore, timely maintenance of equipment is an important part to ensure normal production.
Second, control the material to be crushed. The material to be crushed is also a key issue that affects the normal operation of the machine. If the crushed material has too much water content, viscosity, hardness and blockiness, the machine breaks down more laborious and time consuming. For example, the greater the viscosity of the material, the easier it is to adhere. A material with high viscosity will adhere to the inner wall of the crushing chamber in a jaw crusher. If it cannot be cleaned in time, it will affect the working efficiency of the jaw crusher. In severe cases, it may affect the normal operation of the jaw crusher, and strictly prohibit the nature of the material from exceeding the tolerance range of the machine.
Thirty-three, prevent excessive vibration of the machine. Jaw crusher works normally in the phenomenon of vibration. However, if vibration affects production efficiency excessively or causes damage to the machine itself, it is recommended to add and adjust a belt of the same size as the mat between the adjustment pads. Weaken or feel vibration within a certain range, and weld 2 pressure plates on the adjustment pad to prevent the adjustment plate from falling out.
24. Pay attention to daily cleaning. Every day before the start of the jaw crusher, the dust on the rack should be cleaned up, or the debris should be left in the crushing cavity to prevent the machine from starting because of too much accumulation and abnormal operation. It also affected construction progress.