0086-371-67660555/8613676922906

news-banner

COMPANYNEWS

Causes and solutions for poor quality of vibrating screen

Vibrating screen is a commonly used screening equipment in mine production. It has the characteristics of small size, light weight, high efficiency and many layers. In the production, it will be found that the vibrating screen has poor screening quality, no material feeding or no material feeding, which greatly affects the production. Today we introduce the reason for the poor quality of the screening.
 
The reasons for poor screening quality are:
    1. Screen hole blocking
    When the mud content and water content in the feed are high, the material will stick to the mesh hole and block the mesh hole. At this point, the sieve hole should be cleaned first, and then the water spray amount and the screen inclination angle should be appropriately adjusted.
    2, the screen hole is seriously worn
    When the screen is used for a long time, the screen hole is seriously worn and the screening effect is seriously affected. At this point, the worn screen holes should be repaired. When the wear is serious, the screen should be considered for replacement.
Vibrating screen
    3, the sieve feed is uneven
    When the feed trough of the sieve is too narrow, the material cannot be evenly distributed along the entire sieve surface, so that the sieve surface cannot be effectively utilized, and the screening effect is affected. At this point, the width of the feed chute should be adjusted to make the feed of the sieve uniform.
    4, the material on the sieve is too thick
    The excessive thickness of the material on the sieve may be caused by the increase of the feed amount, the obstruction of the sieve hole, and the small inclination of the sieve surface. At this time, it should be adjusted according to the specific circumstances.
    5, the screen surface angle is not enough
    For a circular vibrating screen, the most common reason for the poor screening effect is that the angle of inclination of the screen surface is not sufficient, and it is necessary to raise the rear support seat. In practical applications, the inclination angle of the screen surface is suitable at 20°. Generally, the inclination angle of the circular vibrating screen is 16 to 20°. If the inclination angle is lower than 16°, the phenomenon that the screen is not smooth or the material is rolled upwards may occur. .
    6, the eccentric block movement direction is not in the same phase
    For linear vibrating screens and high-frequency vibrating screens, the poor screening quality may be related to the direction of motion of the eccentric block, because two sets of eccentric blocks of the same mass are required to perform self-synchronous reverse rotation, and a single direction of vibration is generated at each moment. The exciting force at a fixed angle with the horizontal direction causes the screen box to reciprocate linearly. If they are not in the same phase, the direction of the exciting force does not overlap with the direction of vibration, and the effect of efficient screening is not achieved.

0086-371-67660555

sales@zxcrusher.com

zxcrushers@outlook.com

Related Materials >>
Related Special Topic >>
Contact Form Email: sales@zxcrusher.com,   Phone: 0086-371-67660555,   Whatsapp/Wechat:+86-13676922906

Leave your needs, Our sales manager will contact with you as soon as possible.

Copyright © 2019 Jiaozuo Zhongxin Heavy Industrial Machinery Co.,Ltd.XML HTML