How to solve the rocking phenomenon that occurs during the use of the sand making machine
The sand making machine can make various kinds of rock, sandstone and river pebbles to be used for construction sand with various grain sizes. The sand has a uniform plasmid degree and high compressive strength, far more than the sand produced by natural sand and ordinary hammer sanding machine. Meet the building requirements and improve the quality of the building. The sand making machine has the characteristics of reliable performance, reasonable design, convenient operation and high work efficiency.
If the sand making machine is severely oscillated during work, then there are three possible reasons:
1. The sand making machine may also have obstructions in the impeller flow passage. If there is obstruction in the impeller flow passage, the feeding will be uneven, and the body swings too much. As long as the obstruction on the impeller flow passage is taken out, the body swing can be solved. Too big a problem.
2. It may be that the equipment is too large to cause excessive swinging of the material. When the sand making machine is designed, the feeding size of the equipment is generally 4 to 5 cm. Generally, when the feeding size of the equipment is 3 to 4 cm. The amount of finished sand can be much higher. If the feeding is too large, the equipment will swing too much. If the feeding is too small, the collision is not enough and it is difficult to reach the finished sand.
3. It may be that the wearing parts on the impeller of the sand making machine are worn more seriously. If the wearing parts of the impeller are seriously worn, the internal operation of the sand making machine will be unstable, causing the swing to be too large. At this time, as long as the wearing parts are replaced, the internal impeller of the sand making machine can be balanced.