How to solve sand making machine the problem of rocking
The new sand making machine is 50% more energy efficient than traditional sand making machines. It can make all kinds of rocks, sandstones and river pebbles to be used in construction sand with various grain sizes. The sand has a uniform plasmid and high compressive strength, which is far more consistent with the sand produced by natural sand and ordinary hammer sander. Requirements can improve the quality of the building. The equipment has the characteristics of reliable performance, reasonable design, convenient operation and high work efficiency.
It is also very normal for the sand making machine to encounter problems during work. If the sand making machine is severely oscillated during work, there are three possible reasons:
(1) The sand making machine may also have obstructions in the impeller flow passage. If there is obstruction in the impeller flow passage, the feeding will be uneven, and the body swings too much. As long as the obstruction on the impeller flow passage is taken out, the body can be solved. The problem of swinging too big.
(2) It may be that the equipment is too large due to the excessive particle size of the feed. When the sand making machine is designed, the feed size of the equipment is generally 4 to 5 cm. Generally, the feed size of the equipment is 3 to 4 cm. At that time, the amount of finished sand can be increased. If the feeding is too large, the equipment will be swung too much. If the feeding is too small, the collision is not enough and it is difficult to reach the finished sand.
(3) It may be that the wearing parts on the impeller of the sand making machine are worn more seriously. If the wearing parts of the impeller are seriously worn, the internal operation of the sand making machine will be unstable, causing the swing to be too large. At this time, as long as the wearing parts are replaced, the internal impeller of the sand making machine can be balanced.